Copyright © 2018 ProtectedLogic Corporation, All Rights Reserved
We can handle your testing needs from the development of the test plan and requirements through the design, development and fabrication of the STE needed for verification of systems requirements.

As part of our vertically integrated business model, we perform testing at the module, box and system levels.

Our thermal chambers are used for qualification and acceptance at extended temperature levels to assure compliance to our customer specifications.
The figure above shows us executing an acceptance test on an iMTF system prior to box closure. After the test passed, the unit was closed and assembled into the final configuration shown below and tested again for acceptance..
The iMTF after acceptance testing and prepared for shipping. This system had customer acceptance tests run on it as in the photo above to verify that the unit would operate exactly as a deployed unit would .

This system was built to allow it to install in a standard COTS 19" Rack.

Qualification Testing on Ethernet Switch

STE Housings assembled for mounting in a 19 inch rack.

Acceptance Testing